Superbase® 610 Speed Stripper

Superbase® 601 Professional Strength Stripper
May 25, 2018
Superbase® 871 Green Strip
May 25, 2018

Superbase® 610 Speed Stripper

610 Speed Stripper

No-Rinse Wax and Finish Stripper

This product makes the ready-to-sell equivalent of Essential Brands:

  • #2888 - Speed Stripper
  • #2900 - Super Stripper
  • #2902 - Speed Stripper "Plus"
  • Leaves no alkaline residue behind simplifying rinsing and eliminating recoat problems.
  • Removes heavily burnished acrylics and urethane-fortified acrylics.
  • Use for wet or dry surface stripping prior to recoating.
  • Fast-evaporating, mild pH formula is ideal for stripping sensitive floors such as rubber and linoleum.
  • Optional additives (#941 Powdered Additive and #2200 Coupling Agent) create alkaline stripper.
  • Available in 55 gallon drums or 5 gallon pails.
  •  WARNING: Cancer - www.P65Warnings.ca.gov.

Blending Tips/Quality Control Information

  • 2888
  • This product should be blended with soft water. Hard water will cause a precipitate to form in the ready-to-sell (RTS) product.
  • Always refer to the Safety Data Sheet (SDS) for complete health and safety information
  • RI = 18.0 - 20.0
  • pH = 10.5 - 11.5

To find out more about Refractometers (RI) and pH Testers please visit the RI and pH information Page

  • For 2900
  • Always add Powdered Additive 941 to water first.
  • Powders dissolve quicker and more thoroughly in hot water with good agitation.
  • When hot water is not available, extend the agitation time until all powder is dissolved.
  • This product should be blended with soft water or tap water that is less than 11 grains hardness (200 ppm).
  • 2200 Coupling Agent should not be stored at temperatures below 50°F (10°C).
  • Always refer to the Safety Data Sheet (SDS) for complete health and safety information.
  • RI = 20.0 - 22.0
  • pH = 12.5 - 14.0

To find out more about Refractometers (RI) and pH Testers please visit the RI and pH information Page

  • 2902
  • This product should be blended with soft water. Hard water will cause a precipitate to form in the RTS product.
  • Always refer to the Safety Data Sheet (SDS) for complete health and safety information.
  • RI = 26.0 - 27.0
  • pH = 11.0 - 12.0

To find out more about Refractometers (RI) and pH Testers please visit the RI and pH information Page

Leave a Reply

Your email address will not be published. Required fields are marked *